15687 Autoloader ALE: balance weights not detected. Confirm position Platesetter_VLF Trendsetter_VLF Check for valid NVS parameter wp1/wp2 'set state al wp1|wp2' (weight position 1|2). Reset to zero and run 'bal find' command. Check sensors. NOTE: This error is obsolete in VLF trendsetter version 1.40 and newer. This is not an operator serviceable error. Press resume or reset the machine to continue production. Call CreoScitex response center. The firmware was unable to detect one or both of the balance weights. This could be caused by a corruption of the saved NVS parameter weight positions (wp1/wp2) or failed balance weight sensors. ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:20 2008 PST